Switch Industrial 16Ptos gigabit+4-Ptos. SFP Managed L2

Industrial L2+ 16-Port 10/100/1000T + 4-Port 100/1000X SFP Managed Switch.

Hardware Specifications:
- Copper Ports: 16 10/100/1000BASE-T RJ45 Auto-MDI/MDI-X ports
- SFP Slots: 4 1000BASE-SX/LX/BX SFP interfaces (Port-17 to Port-20)
- Compatible with 100BASE-FX SFP
- Console: 1 x RJ45 serial port (115200, 8, N, 1)
- Switch Architecture: Store-and-Forward
- Switch Fabric: 40Gbps/non-blocking
- Throughput (packet per second): 29.7Mpps@64Bytes
- Address Table: 8K entries, automatic source address learning and ageing
- Shared Data Buffer: 4Mbits
- Flow Control: IEEE 802.3x pause frame for full duplex
- Back pressure for half duplex
- Jumbo Frame: 9Kbytes
- SDRAM: 512Mbytes
- Flash Memory: 64Mbytes
- Reset Button: < 5 sec: System reboot. > 5 sec: Factory Default
- Connector: Removable 6-pin terminal block for power input. Pin 1/2 for - Power 1; Pin 3/4 for fault alarm; Pin 5/6 for Power 2
- Removable 6-pin terminal block for DI/DO interface. Pin 1/2 for DI 0 & DI 1; Pin 3/4 for DO 0 & DO 1; Pin 5/6 for GND
- Alarm: One relay output for power failure. Alarm Relay current carry ability: 1A @ 24V AC
- Digital Input(DI): 2 Digital Input (DI):
Level 0: -24V~2.1V (±0.1V)
Level 1: 2.1V~24V (±0.1V)
Input Load to 24V DC, 10mA max.
- Digital Output (DO): 2 digital output:
Open collector to 24VDC, 100mA
- Enclosure: IP30 aluminum case
- Installation: DIN-rail kit and wall-mount kit
- Dimensions (W x D x H): 76.8 x 107.3 x 152 mm
- Weight: 1,043g
- Power Requirements: DC 9V to 48V. AC 24V
- Power Consumption: 8 watts/27BTU (System on). 17 watts/58BTU (Full loading)
- ESD Protection: 6KV DC

Layer 2 Management Functions:
- Port Configuration: Port disable/enable
- Auto-negotiation 10/100/1000Mbps full and half duplex mode selection
- Flow Control disable/enable
- Power saving mode control
- Port Status: Display each port’s speed duplex mode, link status, flow control status, auto negotiation status and trunk status.
- Port Mirroring: TX/RX/Both
- Many to 1 monitor
- VLAN: 802.1Q tag-based VLAN, up to 255 VLAN groups
- Q-in-Q tunneling
- Private VLAN Edge (PVE)
- MAC-based VLAN
- Protocol-based VLAN
- Voice VLAN
- MVR (Multicast VLAN Registration)
- Up to 255 VLAN groups, out of 4095 VLAN IDs
- Link Aggregation: IEEE 802.3ad LACP/Static Trunk. Support 10 groups of 8-port trunk support
- Spanning Tree Protocol: IEEE 802.1D Spanning Tree Protocol. IEEE 802.1w Rapid Spanning Tree Protocol. IEEE 802.1s Multiple Spanning Tree Protocol.
- IGMP Snooping: IPv4 IGMP (v1/v2/v3) Snooping. IPv4 IGMP Querier mode support. Up to 255 multicast Groups
- MLD Snooping: IPv6 MLD (v1/v2) Snooping. IPv6 MLD Querier mode support. Up to 255 multicast Groups
- Access Control List: IP-based ACL/MAC-based ACL
- ACL based on:
- MAC Address
- IP Address
- Ethertype
- Protocol Type
- VLAN ID
- DSCP
- 802.1p Priority
- Up to 256 entries
- Bandwidth Control: Per port bandwidth control: Ingress: 500Mbps ~1000Mbps. Egress: 500Mbps ~1000Mbps.
- QoS: Traffic classification based, strict priority and WRR
- 8-level priority for switching
- Port Number
- 802.1p priority
- 802.1Q VLAN tag
- DSCP/TOS field in IP Packet
- Synchronization: IEEE 1588v2 PTP(Precision Time Protocol)
- Peer-to-peer transparent clock
- End-to-end transparent clock

Layer 3 Functions
- IP Interfaces:Max. 8 VLAN interfaces
- Routing Table: Max. 32 routing entries
- Routing ProtocolsIPv4 software static routing. IPv6 software static routing

Switch Management
- Basic Management Interfaces: Console; Telnet; Web browser; SNMP v1, v2c
- Secure Management Interfaces: SSHv2, TLS v1.2, SNMPv3
- System Management: Firmware upgrade by HTTP protocol through - Ethernet network
- Configuration upload/download through HTTP
- Remote Syslog
- System log
- LLDP protocol
- NTP